Bare Bones Configurations

Last updated March 2020

This section describes the absolute minimum configurations for using Mobile Momentum. However, your aggregator or provider may require additional parameters.

In bare bones configurations loggers are not required for either SMPP or MM7.

SMPP

A minimal SMPP client can be configured as follows:

smpp {debug_level="debug"}
domain "example.com" {
  SMPP_SMSC_Server  = "10.0.0.1"
  SMPP_SMSC_Port = "2775"
  SMPP_SMSC_System_ID = "GSMSGW"
  SMPP_SMSC_Password = "secret"
  SMPP_ESME_Address = "12345"
}

MM7

A minimal MM7 client can be configured as follows:

mm7 {debug_level = "debug"}
domain "mms.example.com" {
  MM7_MMSC_Server = "10.0.0.1"
  MM7_MMSC_Port = "8192"
  MM7_HTTP_Auth_User = "admin"
  MM7_HTTP_Auth_Password = "admin"
}

A minimal MM7 server can be configured as follows:

mm7_serv {
  MM7_VASP_URI_Paths = ("/mm7/" "/test1/" "/test2/")
  debug_level = "debug"
}

HTTP_Listener {
  Listen ":8089" { }
  Listen "[::1]:8089" {}
}

httpsrv {
  debug_level = "debug"
}

In this case the listener is listening on port 8089 and the server responds to URIs http://host/mm7/, http://host/test1/, http://host/test2/. These are local SOAP endpoints.

URI paths are registered to the HTTP_Listener by the mm7 server. When the HTTP_Listener recognizes a registered URI, it wakes the mm7 server with the incoming mm7 XML SOAP message.

Was this page helpful?

Bare Bones Configurations

SMPP#

MM7#

SMPP

MM7