Skip to main content

msys.dp_config.audit_series.mailfrom

Last updated March 2020

MAIL FROM rate limiting. Note this is disabled by default as there is a potential for a DoS attack using garbage sender addresses.

Find below the sample excerpt included in the dp_config.lua file.

msys.dp_config.audit_series.mailfrom = {
  type = "string",
  interval = 900,
  buckets = 4,
  thresholds = {
    { check = true,
      startv = 0,
      endv = 3,
      threshold = 100,
      honor_whitelist = { "global" }
    }
  },
  options = {
    persist = true
  }
};

The elements of this configuration table are as follows:

type

The only legal value for this element is string.

interval

The time interval that you wish to look at measured in seconds. A reasonable value might be 900.

buckets

A bucket is a window of time of the length defined by "interval". A reasonable value might be 4.

thresholds

Count over which rejection happens. thresholds is a nested table within this configuration option. The following list defines the attributes of the individual thresholds.

check

Whether or not to use this configuration item.

startv

The starting bucket (0 is the current bucket) to query across.

endv

The ending bucket.

threshold

The count that triggers this threshold. When this threshold is exceeded the code 451 is issued with the message Sender message rate limit exceeded.

honor_whitelist

A table listing any applicable whitelists set in the msys.dp_config.whitelist table.

options

This item is a table with the following possible keys:

serialize

Write audit series to log. The value may be true or false; false is the default.

When true, the log will be written to the directory defined by the serialize_dir option in the inbound_audit module. The default value for this option is /var/log/ecelerity/audit_series_persist.

replicate

Defaults to none, but can be cluster to send to all nodes, or manager to send only to cluster manager nodes. This requires explicit configuration in the cluster stanza to operate correctly. For more information see Data Replication.

persist

When set to true, the audit series will be persisted. The persisted series will be reloaded when the engine restarts. The default value is false.

Was this page helpful?